Operation of concrete pump truck these rules to understand a

Operation of concrete pump truck these rules to understand a

Energy-saving control system, with a key switch between high and low pressure function, can be selected according to the working conditions, so that the use of pumping stronger, more difficult to block pipe.

Convenient and fast maintenance system, more efficient pumping, large diameter conveying cylinder, good suction, large pumping flow.

Concrete pump truck is made up of car chassis, internal combustion engine, air compressor, water pump, hydraulic device, etc., in accordance with the general provisions of the car and the relevant provisions of concrete pump.

The concrete pump truck should be placed on a flat and solid site, with no obstacles around and no high voltage transmission lines overhead. The pump truck should not be parked on the slope. After the pump truck in the specified position to keep the fuselage level and smooth, when the material rod feeding, the fuselage tilt can not be more than 3°. After reaching the position, turn on the stop light of the pump truck to avoid collision.

Concrete pump truck fuel, lubricating oil, hydraulic oil, water tank add enough, tire pressure in accordance with the provisions, lighting and signal indicators are complete and good, the hydraulic system works normally, no leakage pipeline; Clean water pump and well-equipped; There is no sundry in the mixing hopper, and the protective grid on the hopper is intact and tightly covered; The conveying pipeline is firmly connected and well sealed. Pipes and hoses used for pipe distribution should be selected according to the provisions of the factory manual. Pipes with diameters exceeding the specified diameter should not be used, and the hoses installed should be tied with anti-release safety belts.